Sd Card Board Cable - HP ENVY *360 15M Maintenance And Service Manual

SD card board cable

NOTE: The SD card board spare part kit does not include the SD card board cable. The SD card board cable is
available using spare part number 924325-001.
Before removing the SD card board cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the SD card board cable:
1. Release the ZIF connector (1) to which SD card board cable is connected, and then disconnect
the SD card board cable from the system board.
2. Release the ZIF connector (2) to which SD card board cable is connected, and then disconnect
the SD card board cable from the SD card board.
3. Detach the SD card board cable (3) from the keyboard/top cover. (The SD card board cable is attached to
the keyboard/top cover with double-sided adhesive.)
4. Remove the SD card board cable.
Reverse this procedure to install the SD card board cable.
38 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 32).
30).