Sd Card Board Cable - HP ENVY 17 Maintenance And Service Manual

Reverse this procedure to install the fingerprint reader.

SD card board cable

NOTE: The SD card board spare part kit does not include the SD card board cable. The SD card board cable is
available using spare part number L20683-001.
Before removing the SD card board cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the SD card board cable:
1. Release the ZIF connector (1) to which SD card board cable is connected, and then disconnect the SD card
board cable from the system board.
2. Release the ZIF connector (2) to which SD card board cable is connected, and then disconnect the SD card
board cable from the SD card board.
3. Remove the SD card board cable (3).
Reverse this procedure to install the SD card board cable.
Bottom cover on page
Battery on page 26).
24).
Component replacement procedures 39