Table of Contents
Advertisement
PR-2000
6.11 Pro Pull Dent Pulling (optional)
6.11.1 Selecting Pro Pull Weld Mode
Figure 6.6 Selecting Pro Pull
weld mode
6.11.2 Pro Pull Component Diagram
Copyright © Pro Spot International, Inc.
2005-2009
Pro Pull is a patented, innovative tool for fast and accurate dent pulling. It
features paintless dent removal functionality (see sec. 6.3.5 "Paintless Dent
Pulling With Pro Pull").
1. Push the Single-Sided weld mode button (fig 6.3). Single Sided Weld Programs
will display on the screen (fig. 6.5). The PR-2000 software defaults to Single Spot
Weld Mode (fig. 6.6).
2. Select ProPull Welding Program by pressing the Left or Right Navigatioin
Buttons (fig. 4.9). Make sure that Pro Pull Welding graphic appears on the screen
(fig. 6.6)
Pro Pull comes with three different
Blocking Plates with Quick-Connect design.
Block window size:
2.5"(63mm) x 1.5"(38mm)
PP-10-04
Block window size:
1.75"(44mm) x 1"(25mm)
PP-10-03
Block window size:
0.75" (19mm) dia.
PP-10-01
6 Single-Sided Welding
Make sure the ground plate is clamped firmly in place on the inside of a
clean metal surface as near as possible to the weld location.
NOTE: Do not attach the ground to the metal you're about to weld on.
When performing other weld tasks such as dent pulling, etc., the ground
attachment location becomes less critical.
Large openings for
great visual control
of the pulling area.
Retrofit point for different end adapters.
Available for most weld guns.
(not included) See prospot.com for more
information.
CLT-55
Electrode
N-38
Nut
CLP-75
Removable weld shaft.
The weld current is
transferred through the shaft
and NO CABLE is required
to transfer the current
Page 30
Advertisement
Table of Contents
