Table of Contents
Advertisement
PR-2000
4.2 About your welder
4.2.1 Welder Overview & Technical Specifications
For optimum results use 3 phase power
The welder is supplied with one of the following voltage and frequency combinations:
Input voltage:
The actual voltage and frequency is stated on the rear panel name plate.
Open circuit output voltage 20v max. E.M.C. classification is C1SPR 11.
Note: For 1-phase installation leave out black wire.
Welding amperage:
Cable length:
Electrode Pressure:
Cooling system:
Welding cable cooling:
Microprocessor program:
Weight (standard):
4.2.2 Getting familiar with your welder
Air
Pressure
Gauge
Air
Pressure
Regulator
Power Switch
Figure 4.1 PR-2000-Front View
WELD CABLES CONFIGURATION
1
Single-Sided Weld Gun cable
Two-Sided spot gun cable
3
AIR HOSE AND COMMAND CABLE CONFIGURATION
5 Air Supply to 2-sided spot gun (compress)
6 Air Supply to 2-sided spot gun (release)
7 Command cable 1-sided gun
8 Command cable 2-sided spot gun
Copyright © Pro Spot International, Inc. 2005-2009
1 or 3 phase
208-240V 50/60 Hz. OR
400-420V 50/60 Hz.
11500A max (3-phase)
6300A max (1-phase)
8' (2.5m) standard
At 7 bars (90 PSI)-280 DaN (616 Lb)
Air (2 fans)
Air cooling
Digital control
213lb (97kg)
Single-Sided ground cable
2
4
Two-Sided ground cable
Input Voltage Cable.
Consult certified electrician
for installation of proper plug and voltage.
4 Operation
The name plate is at the rear of the welder unit.
The required voltage is indicated with a check mark.
Welding output is rated at ??V.
Control Panel
Input Voltage Phase Indicator LED
Lights should illuminate when circuit
breaker on the rear panel is "ON".
(2 lights for 1 phase or 3 lights for 3
phase)
Cable Holder Bracket
Figure 4.2 PR-2000-Back View
Name Plate shows:
Input voltage,
Serial number, etc.
R
Cooling Fan
Air Input
Connect filtered air
100 PSI 7 BAR (min)
Page 11
Advertisement
Table of Contents
