Table of Contents
Advertisement
PR-2000
3 Installation
3.1 General
3.2 Packaging and delivery inspection
3.3 Welder assembly
Figure 3.1
Copyright © Pro Spot International, Inc. 2005-2009
The PR-2000 Spot welder is inspected and tested prior to leaving the factory to
guarantee consistent quality and the highest possible reliability. Follow the instal-
lation tips and operating instructions below to ensure user safety and proper
welder performance.
WARNING! Do not operate or place the welder near water, in wet
locations or outdoors. Risk for injuries or damage to the welder.
WARNING! Do not place the welder on unstable or uneven
ground. The welder might fall causing personal injuries and damage to
the welder. Do not operate on a slope of more than 10º.
IMPORTANT! It is the responsibility of the owner to ensure that
the equipment has been installed as specified in the instructions pro-
vided. It is also the owner's responsibility to ensure that the welder
is inspected in accordance with applicable regulations before it is
put into service. Do not use for thawing out frozen water pipes (17.1)
A grounded electrical plug must be installed (refer to section 3.4 "Connection of
electrical supply").
Check the contents of the shipping container against the packing list, consign-
ment note, or other delivery documentation to verify that everything is included
and in the correct quantity. Check the PR-2000 Spot Welder carefully to make
sure that no damage has occurred during transport. If anything is damaged or
missing, the welder may be unsafe to use till the part is repaired or replaced. If
anything is missing, please contact your supplier. Remove all packaging material
from the welder.
For your convenience, PR-2000 welder ships fully assembled.
Due to differences in wiring codes and connection methods, no electrical plug
comes with the welder. Consult a certified electrician for proper installation of the
electrical plug.
Insert the support arm (boom) as shown in Figure 3.1
3 Installation
Page 8
Advertisement
Table of Contents
