Hi Max Value (Maximum Indicator); Lo Min Value (Minimum Indicator); Revision Counter - Endress+Hauser IO-Link Ceraphant PTC31B Operating Instructions Manual

Ceraphant PTC31B, PTP31B, PTP33B IO-Link
Description
Display: LO
IO-Link: LO Min value (minimum indicator)
Navigation
Description
Revisioncounter (RVC)
Navigation
Description
Reset to factory settings (RES)
Navigation
Description
Endress+Hauser
This parameter is used as the maximum indicator and makes it possible to call up
retroactively the highest value ever measured for pressure.
A pressure that is present for at least 2.5 ms is logged to the maximum indicator.
The maximum indicators cannot be reset.
Display: EF → I → LO
IO-Link: Parameter → System → Device Management → LO Min value (minimum indicator)
This parameter is used as the maximum indicator and makes it possible to call up
retroactively the lowest value ever measured for pressure.
A pressure that is present for at least 2.5 ms is logged to the maximum indicator.
The maximum indicators cannot be reset.
Display: EF → I → Revisioncounter (RVC)
IO-Link: Parameter → System → Device Management → Revisioncounter (RVC)
Counter that indicates the number of parameter changes.
Display: EF → I → Reset to factory settings (RES)
IO-Link: Parameter → System → Device Management → Reset to factory settings (RES)
WARNING
L
Confirming the "Standard Command" with "Reset to factory settings" causes an
immediate reset to the factory settings of the order configuration.
If the factory settings have been changed, downstream processes might be affected
following a reset (the behavior of the switch output or current output might be changed).
‣
Make sure that downstream processes are not started unintentionally.
The reset is not subject to additional locking, such as in the form of device locking. The
reset also depends on the device status.
Any customer-specific configuration carried out at the factory is not affected by a reset
(customer-specific configuration remains).
The following parameters are not reset when a reset is performed:

• LO Min value (minimum indicator)

• HI Max value (maximum indicator)

• Last Diagnostic (LST)
• Revisioncounter (RVC)
Description of device parameters
71