Configuration
STEP 5 – TANK LEVEL CONFIRMATION:
Verify the Height Units, Sensor Height, Probe Length, Maximum Fill-Height & Minimum Fill-Height. All values
were calculated in the previous Dimensional Entry window.
STEP 6 – WRITE TO UNIT:
®
This WebCal
* operation uploads configuration into the sensor. Other features in the section include providing
a custom wiring diagram specific to the signal output and saving the configuration file to your hard drive.
Volumetric Sensor Output
The Volumetric Mode button will
be highlighted in Blue when a
volume output is selected.
* For complete information on the WebCal
flowline.com/webcal-software.
MN300840 REV A8
®
software, please refer to the WebCal
Section Five
®
manual located at
31
|