Table of Contents
Advertisement
Getting Started
SETUP OVERVIEW
Below highlights the initial steps in setting up your sensor for operation.
1. Check Part Number (Section Two)
a. Confirm that the sensor's part number matches the ordered part number and all components
are provided with the model delivered.
2. Measure Probe & Installation (Section Two)
a. Prior to installation, measure the length of the probe. Confirm that the probe length matches the
actual installation location.
b. If the probe length is too long, refer to Cutting the Probe in Section 8.
c. Understand the location of the sensor's Measurement Range as well as Minimum Fill-Height
and Maximum Fill-Height settings.
3. Install the sensor (Section Three)
a. Section 3 contains information on the location and mechanical installation of the sensor.
4. Wire the sensor (Section Four)
a. Section 4 contains information on electrical wiring and power requirements for the sensor.
5. Configure Sensor with WebCal™ (Section Five)
a. Section 5 contains information on using the WebCal
6. Perform an Empty Scan (Section Six)
a. Section 6 contains information on how to run an empty scan.
b. An empty scan may not be required on a sensor that has a coaxial probe.
MN300840 REV A8
®
configuration software.
Section Two
7
|
Advertisement
Table of Contents
