Removing The Handles And Trim - HP 8566B Installation And Verification Manual

To Install Option
010 Instruments
Option 010 mounts the HP 8566B on slides in a rack of 482.6 mm (19
inch) spacing. (Option 010 also contains adapters for mounting in
non-HP racks.)
1. Remove the strap handle on the IF-Display section's left side
panel.
2. Remove the right-rear lock foot and the right-rear top foot from
the IF-Display section. Slide the right-side cover off to the rear.
Install the right-side cover included in the kit, and replace the
rear lock feet.
3. Remove the front-handle trim from each side of the RF and IF-
Display sections. See @ of Figure 2-8.
Figure 2-8. Removing the Handles and Trim
4. Remove the three screws securing each handle, and remove the
handles. See @ and 0.
5. The information-card tray located on the bottom of the RF section
requires a space of approximately 2 cm below the instrument
when rack mounting. See Q of Figure 2-9. (No filler strip is
provided.) If you wish to remove the information-card tray,
remove the feet and tilt stands ( @ and (3J in Figure 2-9).
Installation 2-11