Table of Contents
Advertisement
Instruments Covered
by This Manual
Serial Numbers
Option 462
This option provides 6 dB bandwidths for making
MIL-STD EM1 measurements. In addition to
enhancing instrument capability for MIL-STD
461D and 462D EM1 measurements, Option 462
spectrum analyzers can still make all commercial
EM1 and general-purpose measurements. Option
462 instruments with HP 85662A (top box) serial
prefixes below 3341A were compatible with MIL-STD
Option 857
The HP 8566B Option 857 is used in EMC receiver
applications. This option provides the cumulative
log fidelity and absolute amplitude performance
necessary for EMC receivers to meet their system
specs.
Option 908
Rack Mount Flange Kit (to mount without handles).
This option supplies the necessary hardware and
installation instructions for mounting an instrument in
a rack of 482.6 mm (19 inch) spacing. Option 908 is
also available as a kit (HP part number 5062-3986).
Extra HP 8566B Operating and Programming
Option 910
Manual and an extra HP 8566B Ryformance Ests
and Adjustments Manual.
Option 913
Rack Mount Flanges with Handles (handles provided).
This option supplies the
installation instructions for mounting an instrument
with handles in a rack of 482.6 mm (19 inch) spacing.
Option 913 is also available as a kit (HP part number
5062-3986).
Option 915
This option supplies the HP 8566B troubleshooting
and repair manuals.
This manual contains information for setting up and verifying
operation of HP 8566B spectrum analyzers, including those with
Option 400 (400 Hz operation), Option 857, or Option 462 (6 dB
bandwidths or impulse bandwidths) installed. The procedures in this
manual can also be used to set up and verify the operation of HP
8566A spectrum analyzers that
spectrum analyzers through the installation of an HP 8566AB Retrofit
Kit (formerly the HP 8566A+OlK Retrofit Kit).
Hewlett-Packard makes frequent improvements to its products to
enhance their performance, usability, or reliability. HP service
personnel have access to complete records of design changes to each
type of equipment, based
Whenever you contact Hewlett-Packard about your instrument, have
the complete serial number available to ensure obtaining the most
complete and accurate information possible.
A serial number label is attached to the rear of each instrument
section. The serial number has two parts: the prefix (the first four
necessary
have
been converted into HP 8566B
on the
equipment's serial number.
hardware and
General Information 1-7
Advertisement
Table of Contents
