Connecting the Probe to the Emulator
The external analyzer probe is attached to a connector under the snap-
on cover in the front upper right corner of the emulator. Remove the
snap-on cover by pressing the side tabs toward the center of the cover;
then, pull the cover out. (See figure 4-3.)
Figure 4-3. Removing Cover to Emulator Connector
Each end of the ribbon cable connector is keyed so that it can be con-
nected to the emulator in only one way. Align the key of the ribbon ca-
ble connector with the slot in the emulator connector, and gently press
the ribbon cable connector into the emulator connector. (See figure 4-
4.)
Using the External Analyzer 4-4