Table of Contents
Advertisement
To Install Option
908 and 913
Instruments
Option 908 contains the necessary hardware to mount the HP 8566B
without handles in a rack of 482.6 mm (19 inch) spacing. Option 913
mounts the HP 8566B with handles.
1. Remove the front-handle trim from each side of the RF
and IF-Display sections. See Q of Figure 2-3.
Figure 2-3. Removing the Handles and Trim
2. Remove the three screws securing each handle, and remove the
handles. See Q and (3J
3. The information-card tray located on the bottom of the RF section
requires a space of approximately 2 cm below the instrument
when rack mounting. See 6 of Figure 2-4. (No filler strip is
provided.) If you wish to remove the information-card tray,
remove the feet and tilt stands ( @ and @ in Figure 2-4).
Installation 2-7
Advertisement
Table of Contents
