ETC echoflex MOS-MT Series Installation Manual page 6

The red LED will blink every time a motion sensor trigger is detected. The
test times out in 100 seconds. If a faster exit from walk test mode is required,
press and hold the teach button for 10 seconds.
PIR Audio / EEP configuration mode Mode
The PIR Audio /EEP configuration mode has a sub menu which allows:
• PIR sensitivity select
• Occupancy duration select
• EEP setting select
PIR sensitivity select mode
The
sensitivity. False occupancy states caused by other elements can be reduced
by selecting the minimum sensitivity level. The default setting is high
sensitivity.
1. To enter sensitivity adjust mode, press and hold the teach button until
the green LED begins to blink (about 6 seconds).
2. A quick press and release of the button at this point will allow you to
select between test modes. Pressing and releasing the teach button
scrolls through the LED indicators. When the red and blue(A) LEDs are
blinking, press and hold the teach button again for 6 seconds to enter
PIR Audio /EEP configuration mode.
3. A quick press and release of the button at this point will allow you
to select between sub menu modes. When the green LED repeats
double blinks, hold the teach button for 6 seconds to select sensitivity
adjust mode.
A press and release of the button will allow you to scroll through the settings
as shown in the table below.
To select a setting press and hold the teach button for 6 seconds when the
desired LED is blinking. To exit without saving, allow the test to time-out in
60 seconds.
Occupancy duration select
of time an occupancy event will hold before an unoccupied signal is
transmitted.
To enter occupancy duration select mode,
1. Press and hold the teach button until the green LED begins to blink
(about 6 seconds).
2. A quick press and release of the button at this point will allow you to
select between test modes. Pressing and releasing the teach button
scrolls through the LED indicators. When the red and blue(A) LEDs are
blinking, press and hold the teach button again for 6 seconds to enter
PIR Audio /EEP configuration mode.
3. A quick press and release of the button at this point will allow you to
select between sub menu modes. When the red LED repeats double
6
Setting
High
Medium
Low
allows the user to change the amount
allows the user to change the PIR
Indication
1 blinki
2 blinks
3 blinks