Table of Contents
Advertisement
8ft
(2.4m)
0
8ft
(2.4m)
10ft
(3.0m)
12ft
(3.7m)
12.2m
9.1m
(40ft)
(30ft)
Mounting the Sensor
The mounting location of the sensor is important as this will directly affect
the receivers reception of the telegrams. Before installing, refer to the
sections in the guide detailing the installation of wireless devices, layout tips
and test operation modes.
i
Note:
i
Note:
For the best sensor performance, mount the sensor so at least one of the
solar cells is facing a light fixture. The sensor will operate in low light levels
however for best performance, a minimum of 5 foot candles (54 lux) must
be maintained. If the controlled lights in the space are dimmable either
manually or via daylight harvesting, insure the light level at the lowest
dimmed level meets this 5 FC requirement. If the light value does not meet
this requirement, install a battery.
Installing or Replacing the Start Assist Battery
The battery is not required for normal operation. The battery (model CR2032)
may be useful for installation purposes (test mode operation and linking) or
for applications where there are long periods of no light.
1. Using a small screwdriver for leverage, insert under the clear plastic
cover at one of the relief tabs in the base plate and pull up. You will
need to repeat with at least two tabs until the cover pops free.
2. Using a small flat head screwdriver or pen as a lever, insert pointed
end under the clear plastic battery retaining clip's edge and pop the
clip off. Using a finger, remove the old battery by pulling the battery
free from the holder.
3. Insert the new CR2032 coin cell battery with the + positive side facing
up and press in place with your finger.
4. Align the two straight edges of the retaining clip with the battery
holder and press the clip in with your finger.
5. Replace the cover over the sensor aligning the button hole with the
teach button and press in place.
2.4m
7.3m
4.3m
(24ft)
(14ft)
(8ft)
6.1m
3.0m
(20ft)
(10ft)
The sensor cannot detect motion through solid objects including
items placed by a tenant, such as file cabinets or shelves.
Do not locate the sensor near forced air vents as hot moving air may
cause the sensor to false trigger movement. Leave at least 4' (1.2 m)
minimum between air vents and the sensor
0
2.4m
0.9m
0.9m
0.9m
4.3m
(3ft)
(3ft)
(3ft)
(8ft)
(14ft)
3.0m
0
(10ft)
7.3m
(24ft)
Large Range Lens (B)
1900 sq.ft @ 9 ft.
6.1m
9.1m
(20ft)
(30ft)
12.2m
(40ft)
3
Advertisement
Table of Contents
