Table of Contents
Advertisement
Software Installation for Windows 95/98
This procedure describes how to install the DataFire GO! PRO software using the
Microsoft Plug & Play system.
1. Shut down the computer.
2. Physically install the PC Card into a PCMCIA slot as shown below.
3. Turn the computer back on.
4. When the system discovers the PC Card, follow the Windows prompts as follows:
Ÿ
To select the source for the driver, choose: Driver from disk provided by
hardware manufacturer.
Ÿ
Insert the CD and then select the CD drive letter.
5. The software that enables PSTN (modem) support will now be installed. When
complete, you can verify that you have modem support by following the procedure
on the next page.
7
Advertisement
Table of Contents
