Table of Contents
Advertisement
•
SX128 MODEM X75 is used for 64Kbps (1 B-Channel only) ISDN
connections with the X75 protocol (i.e. Eurofile transfer protocol).
•
SX128 MODEM V120 is used for 64Kbps (1 B-Channel only) ISDN
connections with the V120 protocol. This is required for Compuserve access.
•
SX128i-Line#1 and SX128i-Line#2 devices are used for 64Kbps and/or
128Kbps ISDN connections using TAPI compliant software (RAS, Internet
Explorer, Netmeeting, etc.).
Note: Because PSTN and GSM/PCS connections use the same software device
(56K PC Card Caller ID) both cable options cannot be physically installed when
making a connection. For GSM/PCS connections the PSTN cable must be removed
and for PSTN connections the GSM/PCS cable must be removed.
4. Press Next.
5. Type in the Area code, Telephone number, and Country code of the site to
which calls will be made. Then press Next.
6. Press Finish.
Configuring Two-Channel PPP Multilink Connections
(Windows 95/98)
This procedure describes how to configure PPP Multilink for making two-channel
ISDN calls. You can use it to make calls to any other ISDN device implementing
standard PPP Multilink protocol.
1. Double-click on My Computer and then choose Dial-Up Networking.
2. Press Next if prompted and then double-click Make New Connection.
3
Next, supply a name for the connection.
4. Select the SX128I-Line#1 or SX128I-Line#2 device required for this
connection
15
Advertisement
Table of Contents
