Operation
Remote Configuration Using an MMS Controller
Remote Configuration over a link between two modems can be performed with SNMP commands
from an MMS controller.
Remote Configuration Procedure (MMS Controller)
1. At the local site, select the MIB variable Remote Configuration, and enable MMS
enumeration.
2. Perform normal dialing to establish connection between local and remote modem.
3. Send configuration changes to the remote modem.
4. Terminate the session according to the following options:
•
To save changes made during the session, terminate the session by setting the MIB
variable End Remote Configuration at the remote modem to Update.
•
To end the session without saving changes, set the MIB variable to No Update.
Special Considerations
The following MMS commands are invalid during a Remote Configuration session:
•
Modem reset
•
Modem in/out of service
•
Make clear/busy
•
Diagnostic tests
•
Test results
•
Remote configuration password
•
All dialing operations except Terminate call
•
Front panel inhibit/enable
060R122-000
Issue 15
SpectraComm Dual V.34 Modem
Installation and Operation
Command Mode Overview
3-25