Table of Contents
Advertisement
Installation
Verifying Your Connections
Your modem should now be connected. You can verify all your connections by following the steps
listed below.
1. To verify that the power supply is connected properly, see if the ON LED is on. If not, then
either the power supply is not connected properly, or the modem is not functioning.
2. To verify that the switched network telephone line is connected properly, place a voice call
using a telephone.
3. If you are using a terminal as your DTE, proceed to the next step. If you are using a computer
as your DTE, then run your communications software and configure it for terminal emulation.
If you are using an intelligent communications software package, it may be necessary to
configure it for interactive mode. Refer to Chapter 3, Operation for further details.
4. Type the command AT followed by a carriage return on the DTE. The modem should respond
with an OK message. If the modem does not respond with an OK message, then either your
DTE interface cable is not connected properly or your DTE is not configured properly.
Note
Refer to
Table 1-3
2-8
for a complete list of compatible DTE configurations such as speed and parity.
SpectraComm Dual V.34 Modem
Installation and Operation
060R122-000
Issue 15
Advertisement
Table of Contents
