Table of Contents
Advertisement
AT Command Set Operation
DCE rate limit
&G n
&G10
&G11
&G12
&G13
&G14
&G15
&G16
&G17
\G n
Modem-to-modem flow
control
H n
Hookswitch
060R122-000
Issue 15
Sets the maximum rate for the modem to make a VF connection to a remote modem.
The allowable rates are: 2.4 to 28.8 kbps for V.34, 4.8 or 9.6 kbps for V.32 only, and
4.8 to 14.4 kbps for V.32 bis only.
If you set a rate that is outside the range of rates available for the modulation in use,
the modem will use the closest available rate.
&G5
4.8 kbps, maximum rate
7.2 kbps, maximum rate
&G6
&G7
9.6 kbps, maximum rate
12 kbps, maximum rate
&G8
14.4 kbps, maximum rate
&G9
16.8 kbps, maximum rate
19.2 kbps, maximum rate
21.6 kbps, maximum rate
24 kbps, maximum rate
26.4 kbps, maximum rate
28.8 kbps, maximum rate
31.2 kbps, maximum rate
33.6 kbps, maximum rate (DEFAULT)
Provides modem-to-modem flow control for non-error corrected data links that
require a constant speed DTE interface (Wire Mode).
Disables flow control between the two modems.
\G0
\G1
Enables bidirectional modem flow control based on XON/XOFF signaling. The XON/
XOFF signals are detected, acted on, and deleted from the data stream.
Provides unidirectional flow control: the modem may send XON/XOFF signals to the
\G2
remote modem, yet ignore and pass through to its DTE any that it receives as VF
signals.
\G3
\G1
Same as
, except after they are acted upon, XON/XOFF signals are passed
through to the DTE instead of being deleted.
Controls the off-hook relay. This command is not affected by factory defaults.
Opens the relay for on-hook condition (modem hang-up).
H0
H1
Closes the relay for off-hook condition. Modem remains off-hook until termination of
on-line status, or until the
SpectraComm Dual V.34 Modem
Installation and Operation
AT Command Reference Tables
H0
command is issued.
4-7
Advertisement
Table of Contents
