Table of Contents
Advertisement
AT Command Set Operation
Display AES Encryption
%W
Key
Display SAM Information
Save user profile
&W n
*W n
Remote config
Call Progress Monitor
X n
Transmit clock source
&X n
*X n
Remote config exit
4-20
Displays the AES Encryption Key. The private key will not display unless the modem
is configured for encryption (
by factory defaults.
Displays the SAM ID, SAM PIN, SAM Private Key, Primary Server phone number and
Secondary Server phone number. The private key will not display unless the modem
is configured for SAM mode (
Instructs the modem to write the current user-defined and storable options into
memory. Up to four user configuration profiles, where
This command is not affected by factory defaults. Refer to the
a stored user configuration profile.
Controls remote configuration. This command is not affected by factory defaults.
Initiates a remote configuration session with the next call.
*W1
Stops the initialization of a remote configuration before dialing.
*W0
Controls which Call Progress Monitor (CPM) signals are monitored and reported to
the local DTE. Country configuration definitions can restrict the storage function.
Forces blind dialing, disables all CPM, and only the CONNECT message is sent for
X0
all established links.
X1
Forces blind dialialing, disables all CPM, and the CONNECT message includes the
connected speed.
Enables CPM for pre-dial signals (dialtone) only, and the CONNECT message
X2
includes connected speed.
Forces blind dialing, enables CPM for post-dial signals only (busy, unobtainable
X3
number, etc.), and the CONNECT message includes connected speed.
Enables CPM response codes and monitoring, and the CONNECT message
X4
includes connected speed.
Enables all CPM response codes and monitoring, including ringback detection,
X5
CONNECT message includes connected speed.
Selects the clock source when the modem operates in synchronous Data Mode
&X0
Directs the modem to use its internally generated clock source.
Selects the DTE clock as a source for the modem.
&X1
&X2
Selects the modem's RECEIVER derived timing clock to be used in the transmitter.
Controls remote configuration exit. Before disconnecting, you must use the
&Yn
and
command to save Power ON defaults. This command is not affected by
factory defaults.
*X0
Terminates the session without saving changes.
Terminates the session and saves changes.
*X1
SpectraComm Dual V.34 Modem
Installation and Operation
AT Command Reference Tables
%S8
,
%S9
or
%S11
). This command is not affected
%S16
%S17
or
).
n
is memory cell location 0 - 3.
Z n
command to load
&Zn
060R122-000
Issue 15
Advertisement
Table of Contents
