Table of Contents
Advertisement
Operation
Cell Passwords
The %Pn command allows you to configure or disable cell passwords in the modem.
•
With SteadFast Security, only one identical cell password is stored in memory cell 0 of both
the answering and the originating modem.
•
With Online Security, the user can store up to ten cell passwords in the answering modem in
memory cells 0 through 9.
•
To delete a password in a specific cell, type AT%Pn=[carriage return], where n is cell 0
through 9. Each password must be deleted individually from the cell.
•
With RADIUS Security, the user can store cell passwords in the modem in order to make
Online Security available under special conditions. This use of cell passwords provides a lesser
degree of security but allows access if the SCM fails or all RADIUS servers fail. Refer to the
SCM Installation & Operation Manual, Appendix B for detailed information on RADIUS
Security Special Conditions.
Note
AT commands associated with security (
command
&F
Configuring Modem Response
With SteadFast and/or Online Security enabled, the user can configure the modem(s) for a Pass-thru
Response or a Callback Response. Refer to
in security features, as well as the RADIUS and AES Encryption options.
•
If the %S2 command is used, it is strongly recommended that the escape character sequence
be disabled by entering S2=128 and then pressing Enter.
3-8
%P
. Refer to Chapter 4 for
AT Command Details
SpectraComm Dual V.34 Modem
Installation and Operation
,
%F
,
%X1
or
&Z
) are not affected by the factory default
and
&Fn Fixed Configuration Profiles
Table 3-3
for the commands which control these built-
Security Overview
.
060R122-000
Issue 15
Advertisement
Table of Contents
