Table of Contents
Advertisement
AT Command Set Operation
Identification and
I n
checksum
&I
Front Panel Lockout
Dial-in session timer
%In
Redial delay
%Jn
Character abort
%K n
060R122-000
Issue 15
Requests modem identification and checksum codes to be transmitted to the DTE.
I0
Displays the modem product code. The V.34 product code is 288.
Displays the stored checksum calculated for the modem's configuration.
I1
(reserved for future use)
I2
I3
Displays the revision level of the modem's firmware (an alphabetical character)
followed by the OK message.
Displays the following modem feature information:
I4
Firmware Level
Product Type
- Displays product code ( see
security setting:
Management System
Sync Compression
Country Code
- Displays three-digit country code. When encryption is
enabled, country code must be 001 for USA or Canada.
VF Card
- Displays
DTE Card
- Displays
Leased Line
- Displays status as
Displays the modem serial number
I5
Controls the modem's front panel switches.
Enables front panel.
&I0
Disables front panel.
&I1
Sets the maximum time allowed for a dial-in connection when no valid encrypted
secure access command is received (e.g., in the event of a remote configuration
session or an unauthorized access attempt).
Enter value of 1, 2 or 3. (Minimum is 10 minutes, increments by 10 minutes.)
%I
and
S41
commands are mutually exclusive.
Sets delay before the modem redials the SAM server for a new private key.
Enter a value of 0 for 20 seconds (default). Enter 1 to 30 for 1 to 30 minutes.
%J
%H
and
commands are mutually exclusive.
Controls the character abort option. It is only available when the modem is in AT
operation and asynchronous mode.
Enables character abort: any character typed at the DTE within 2 seconds after the
%K0
modem goes off-hook will abort the dialing process.
Disables character abort.
%K1
SpectraComm Dual V.34 Modem
Installation and Operation
AT Command Reference Tables
- Displays the firmware version in numeric format.
I0
SEC
for Radius,
SEC EC
for both Radius and Encryption, or
SAM
for Secure Access Modem Authentication.
- Displays status of MMS control as
- Displays status as
ON
NONE
(Not applicable in the Dual V.34 Modem)
232
(Not applicable in the Dual V.34 Modem)
2W
.
), or displays the configured
EC
for AES Encryption, or
ON
or
OFF
.
or
OFF
.
4-9
Advertisement
Table of Contents
