Table of Contents
Advertisement
Operation
Modem Main Menu
[1] AT SESSION
[3] DTE STATUS
[0] RETURN TO SHELF INVENTORY
Select:[ ]
Figure 3-3
5. Type the number that corresponds to the desired menu function and then press Enter.
Each Main Menu function is described below.
Note
You can return directly to the Shelf Inventory screen from any V.34 terminal interface screen by pressing
the Control (Ctrl) key and the letter C at the same time.
AT Session Terminal Interface Screen
The AT Session selection from the Main Menu enables you to perform configuration by means of
the terminal interface. Making this selection prepares the unit to accept a subset of the AT
commands that includes the configuration commands and commands that query the unit for
information, such as set help, identification or checksum.
Special Considerations
•
The following commands cannot be used during a terminal interface AT Session:
•
Remote configuration
•
Call control (dialing or answering)
•
Test functions
•
Repeat last command (A/)
•
Escape sequence (+++) to place a unit configured for private line operation into
command mode
•
Selecting AT Session through the terminal interface automatically forces the unit into the AT
command mode. The unit can be also be configured via the %Vn command to accept
configuration commands in the AT format or in any one of three V.25bis formats.
•
If you intend the unit to accept V.25 bis commands, be sure to make the %V setting at the end
of the AT Session. If you need to save a User Configuration Profile with %V set for V.25 bis
commands, you must include that command (&Wn) on the same line with the %V command.
Once you press the Enter key to put the command line into effect, the unit cannot accept any
further standard AT commands.
3-40
DUAL SPECTRACOMM V.34
SLOT: 17
LINE: 1
[2]
ALARMS
[4]
CALL STATISTICS
Terminal Interface Main Menu
SpectraComm Dual V.34 Modem
Installation and Operation
Modem Main Menu
060R122-000
Issue 15
Advertisement
Table of Contents
