Tw 100 System - Pace HW 100 HeatWise Operation And Maintenance Manual

4. Once the tip has reached the desired heat level, the LED indicator will turn green and the
system is ready to use.
The HW 100 system comes standard with an Auto-Setback and Auto-Off Features. These are pre-
programmed for 30 minute SetBack and 30 minute Auto Off, which can be turned off by the switch on
the bottom of the unit. When Setback mode has been entered, the heat level will be adjusted to 3.5.
Setback can be exited by either thermally shocking the tip by placing it in a dampened sponge or by
simply switching the unit off for a brief moment. Auto Off can be reset by switching unit off then on.
TW 100 TempWise System
The TW 100 system is very easy to adjust and operate. The following instructions detail system
features and operation of the system.
Temperature Setback time, Auto Off) is contained in the "Programming Your System" portion of this
manual.
1. Ensure that the Set-Up procedure has been performed.
Verify the following:
a) Handpiece connection to the power source.
b) Proper tip installed in handpiece.
c) Power cord connection between an appropriate
AC supply and the power source.
2. Turn the Power Switch On ("I"). The display will begin
to increase as the TD 100 handpiece heats up.
3. Press the Scroll Up
displayed, immediately perform step 4.
NOTE: If a Password has been previously programmed into the
system, "EP" will be appear on the LED Display at this point.
When this message appears, the operator must enter the
correct Password before adjusting the temperature.
4. Adjust the temperature by pressing and holding Scroll Up
Observe the display as the Set Temperature increases first in increments of 5°, then in
increments of 10°. When the desired temperature is reached, release the key.
NOTE: The Set Temperature can only be within the set temperature limits. If the lower limit
is reached, the display will read off. If the upper limit has been reached, the display
will read "HiL". Temperature limits can be adjusted in the programming menu. See
"Programming Your System" section.
5. Observe the Digital Readout as the temperature reaches and stabilizes at the Set Tip
Temperature.
6. The system can be manually forced into Temperature Setback by pressing and holding
the Scroll Down (t) Key and the Scroll Up
7. When the display begins to blink, the system is in Temperature Setback mode and will
reduce the set temperature to 177°C (350°F). NOTE: If Auto Off has been enabled in
the programming menu, the system will enter Auto Off (temperature Off and LED Display
flashing "Off") after the preset time of handpiece inactivity. Auto Off can be exited by
pressing any key.
8. To exit Temperature Setback mode, perform any one of the following:
a) Press and release a Key (
b) Wipe the hot handpiece tip on a wet sponge to thermally load the tip.
c) Turn the Power Switch Off ("0") and then back on ("I").
©2004 PACE Inc., Annapolis Junction, Maryland
All Rights Reserved
Information regarding changing of system options (e.g.,
Key. The Set Temperature is now
Key.
, or ). This is the preferred method.
LED
Indicator
Program/
Menu Button
Scroll Up/Down
Buttons
Key or Scroll Down key.
Page 8 of 17