Electrical Connection (Non-Canada) - 4 Wire Cord - Frigidaire FFLE3911QW Technical & Service Manual

1. Turn OFF the power supply to the outlet.
2. Remove the screw securing the terminal block access
cover in the lower corner on the back of the dryer.
3. Install a UL-approved strain relief according to the
power cord / strain relief manufacturer's instructions
in the power cord entry hole below the access panel.
Simultaneously, the strain relief should be loosely in place.
4. Thread an UNPLUGGED, UL-approved, 30 amp. power
cord, NEMA 10-30 type SRDT, through the strain relief.
5. Attach the power cord neutral (center wire) conductor
to the SILVER colored center terminal on the terminal block.
Tighten the screw securely.
6. Attach the outer conductors of the two remaining
power cords to the outer BRASS colored terminals on the
terminal block. Tighten both screws securely.
WARNING
ELECTRICAL SHOCK HAZARD
Do not make a sharp bend or crimp wiring /
conductor at connections.
7. Follow the manufacturer's guidelines for firmly securing
the strain relief and power cord.
8. Reinstall the terminal block cover.
IMPORTANT
To move a dryer from a 4-wire system and to install
it in a 3-wire system, move the internal ground from
the center terminal back to the GREEN screw next
to the terminal block.
NOTE
If a terminal screw falls during cord installation, it
can be retrieved in the terminal screw recovery slot
below the access panel.
6.5.4 Electrical Connection
(non-Canada) - 4 wire cord
4-wire receptacle (NEMA
type 14-30R)
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before servicing
could result in personal injury or even death.
1. Turn OFF the power supply to outlet.
2. Remove the screw securing the terminal block access
cover in the lower corner on the back of the dryer.
3. Install a UL-approved strain relief according to the
power cord / strain relief manufacturer's instructions in the
power cord entry hole below the access panel. At this time,
the strain relief should be loosely in place.
4. Thread an UNPLUGGED, UL-approved strain relief, 30
amp. power cord, NEMA 14-30 type ST or SRDT, through
the strain relief.
45