Connect The Can Bus Cable; Install The Logic Power And Ground Connections - Raven AccuBoom SCS 460 Installation Manual

C 3
HAPTER

CONNECT THE CAN BUS CABLE

FIGURE 13. CAN Bus Cable Connected to the CAN Power Cable
1. Connect the single end of the CAN bus cable (P/N 115-0171-326) to the machine's existing product control CAN
cable.
2. Connect the other end of the CAN bus cable to the SCS console AccuBoom cable (P/N 115-1001-008).
3. Install a CAN terminator (P/N 063-0172-369) on the remaining branch of the CAN bus cable.

INSTALL THE LOGIC POWER AND GROUND CONNECTIONS

FIGURE 14. Ground
1. Route and connect the two ground wires from the AccuBoom cable to the secure battery ground located under
the dash in the right corner of the cab.
2. Connect the high current power wires (10 and 12-gauge wires on the AccuBoom cable) to a fused connection
within the fuse box.
3. Connect the logic power wire (16 gauge small wire on the AccuBoom cable) to a source of clean, switched
power.
16 SpraCoupe 3000/4000 with SCS 460 Console AccuBoom Installation Manual