Raven AccuBoom SCS 460 Installation Manual page 17

FIGURE 8. Boom Valve Wires Connected
1- Wire
Connected to the
Negative Boom
Switch Wire
7. Connect the AccuBoom 1+ wire to the parallel positive boom switch wire.
8. Locate the AccuBoom wire connector from the 10-wire bundle for the 1- boom switch.
9. Connect AccuBoom 1- wire to the negative boom switch wire that was disconnected in step 4.
NOTE: Refer to Table 3 below when connecting the AccuBoom cable to the boom switches.
TABLE 3. Boom Switch Connections
AccuBoom Wire Color
Black or Gray
Brown
Blue
Black/White
Brown/White
10. Locate the AccuBoom wire connector from the 5-wire bundle for the first boom switch.
11. Connect the AccuBoom wire to the positive terminal on the boom switch.
NOTE: The positive terminal is where the positive parallel wire connector was previously connected.
12. Repeat the steps above for the remaining boom sections, referring to the appropriate table for the number of
boom sections present.
Manual No. 016-0171-079 Rev F
3-Boom System
Boom Number
1
2
3
Not Connected
Not Connected
ACCUBOOM INSTALLATION
1+ Wire Connected
to the Parallel
Positive Boom Switch
Wire
5-Boom System
Boom Number
1
2
3
4
5
13