Raven AccuBoom SCS 460 Installation Manual page 25

Spracoupe 3000 series; spracoupe 4000 series

Hide thumbs Also See for AccuBoom SCS 460:

Table of Contents

CHAPTER

The AccuBoom CAN control node (P/N 063-0172-316) features several green light-emitting diodes (LEDs) which

may be used to diagnose issues within the AccuBoom system.

NOTE:

If the LEDs are not displayed as outlined in the figure below, check the CAN connections and the

control cable connections on the node. If the issue persists, contact your local Raven dealer for

additional technical support.

NOTE:

All boom switches must remain in the off position while AccuBoom control is in operation.

FIGURE 1. AccuBoom CAN Control Node LEDs

Manual No. 016-0171-079 Rev F

T ROUBLESHOOTING

C H A P T E R 5

Logic Power - Lit when +12 V current

is supplied to the node.

HC (High Current) Power - Lit when

High Current Power is supplied to the

node.

Micro 1 Hz - Flashes once every

second during processor activity.

CAN Rx - Flashes to indicate CAN

messages are being received by the

node.

CAN Tx - Flashes to indicate CAN

messages are being transmitted from

the node.

Diag (Diagnostics) 1/2 - Currently not

used with the AccuBoom™ system.

Table of Contents