Functional Check - Kessel Aqualift S XL Instructions For Installation, Operation And Maintenance

Date / Time
• Set the respective flashing figure in date and time and confirm with OK. Following the last entry, the menu
item Product type
Product type
• Select Aqualift Mono or Duo pumping station and confirm with OK, the menu item
System variant
• Select the relevant system variant and confirm with OK, the menu item
Power quantity
• Select the relevant power quantity and confirm with OK, the menu item
Maintenance interval
• Select the required maintenance period or enter accordingly and confirm with OK, the menu item
appears, initialisation is complete.
4.7.2

Functional check

Follow the safety instructions in chapter 3.
• Switch off the pumping station (if necessary, disconnect the mains power plug)
• If necessary, open the cover of the system tank (inspection chamber)
• Fill the system tank with water until the switching level of the system is exceeded
(at least until the pumps are completely covered with water).
• Switch on the pumping station (if necessary, plug in the mains plug).
– If installed, check whether the control unit is initialised
– Pump starts up automatically
– The pump pumps out water until the switching-off level is reached (pump head visible again)
– Pump switches off automatically
• If installed, check the control unit for errors/alarm signals. In case of errors/alarm signals, please follow the
instructions in Chapter 7.
2019/12
is displayed.
Installation
40 / 148
System variant
Performance quantity appears.
Maintenance date appears.
is displayed.
System info
010-993