Cisco CDE 220 Series Hardware Installation Manual page 189

Appendix A Technical Specifications
CDE475 Specifications
Table A-6
Table A-6
Rack Units
Power
AC Power Rating
DC Power Rating
AC Electrical Input
DC Electrical Input
DC Connector Type
Power Connector Cables
Operating Relative Humidity
Nonoperating Relative
Humidity
Operating Temperature
Nonoperating Temperature
Operating Altitude
Dimensions (H x W x D)
Weight (fully configured)
CDE Management
Table A-7
Table A-7
Data Rate
Ports
Input Cables
lists the technical specifications and management information for the CDE475.
CDE475 Specifications
4
100 to 240 VAC or –48 VDC redundant power supplies included in
all models
1280 W peak
1000 W peak
•
•
See the
DC input voltage range: –48 VDC to –60 VDC
See also the
page
Molex
Wire cable gauge 10 AWG
8 to 90% (non-condensing)
5 to 95% (non-condensing) at temperatures of 73°F to 104°F (23°C
to 40°C)
50 to 95°F (10 to 35°C)
–104 to 158°F (–40 to 70°C)
0 to 3028 m
7.0 x 17.2 x 26 in. (17.8 x 43.7 x 66.0 cm)
122 lb (55.39 kg)
lists the management for all CDE models.
CDE Management
2 Gbps maximum
Console port: DB-9 RS-232
10/100/1000 Mbps Ethernet interface: RJ-45 (management)
The CDE280 Engine has one RS-232 serial port (RJ-45 connector)
Note
Console port: DB-9 female serial cable
Ethernet interface: RJ-45 Category 5E or higher cable
Cisco Content Delivery Engine 205/220/250/280/285/420/460/475 Hardware Installation Guide
AC input voltage low range—Minimum: 100 VAC,
Maximum: 127 VAC
AC input voltage high range—Minimum: 200 VAC,
Maximum: 240 VAC
"If AC Power Supplies Are Installed" section on page
"If DC Power Supplies Are Installed" section on
2-12.
CDE475 Specifications
2-9.
A-7