Cisco CDE 220 Series Hardware Installation Manual page 177

Chapter 6 Installing the VQE and Initially Configuring a CDE
•
•
Installing a CDE
To install a CDE, do the following:
Ensure that the CDE is powered off.
Step 1
Attach the USB DVD-ROM drive to any available USB port at the rear of the CDE (see
Step 2
page
Attach a power cord and keyboard to the CDE, and attach a terminal server to the CDE serial port and
Step 3
ensure the serial communications are properly configured (see
Insert the VQE installation image CD in the DVD-ROM drive.
Step 4
The system boots from the image on the CD. This requires a terminal server to be connected to the serial
port of the CDE. All communication is done through the serial port (see the
on page 6-2
Power on the external USB DVD-ROM drive.
Step 5
To start the booting process, see
Step 6
Visual Quality Experience Application, Release
Figure 6-1
Re-Manufacturing and Installing CDE280
To install the CDE280 with the help of CIMC, do the following:
8 bits
–
No parity
–
VQE image CD (if installing VQE software on the CDE250 2V0). For the procedure, see the
"Installing VQE Release 3.11 Software"
Experience Application, Release 3.11.
Console connection
1-10).
for terminal server settings).
ISO Clean Installation
Cisco Content Delivery Engine 205/220/250/280/285/420/460/475 Hardware Installation Guide
section in the Release Notes for Cisco CDA Visual Quality
"ISO Clean Installation" section in the
3.11.
Re-manufacturing a CDE
Figure 1-9 on
Figure 1-9 on page 1-10).
"Before You Begin" section
Release Notes for Cisco CDA
6-3