Cisco CDE 220 Series Hardware Installation Manual page 175

Installing the VQE and Initially Configuring a
CDE
This chapter describes the initial installation of the Cisco VQE software application suite, and the initial
configuration of a CDE.
•
•
If you receive a new CDE250 go to the
page
If you receive a new CDE280 go to the
page
If you need to re-manufacture a CDE for any reason, see the
page
Launching a New CDE250 for the First Time
To launch a CDE250 for the first time, see
for Cisco CDA Visual Quality Experience Application Release 3.11.
Launching a New CDE280 for the First Time
For CDE280, you can use the CIMC to manage your device. To use the CIMC, you have to configure it.
This section describes the following tasks:
•
•
•
•
•
Configure the CIMC IP
To configure CIMC IP, see
Launching a New CDE250 for the First Time, page 6-1
Re-manufacturing a CDE, page 6-2
6-1.
6-1section on page.
6-2.
Configure the CIMC IP, page 6-1
Configure Remote Presence, page 6-2
Connect to the Console, page 6-2
Configure VQE Software, page 6-2
Configuring SNMP, page 6-2
"Configure the CIMC IP" section on page
Cisco Content Delivery Engine 205/220/250/280/285/420/460/475 Hardware Installation Guide
C H A P T E R
"Launching a New CDE250 for the First Time" section on
"Launching a New CDE280 for the First Time" section on
"Re-manufacturing a CDE" section on
"VQE Software Installation Types"
6
section in the Release Notes
4-3.
6-1