Cisco CDE 220 Series Hardware Installation Manual page 155

Chapter 4 Installing the VDS Internet Streamer Software and Initially Configuring a CDE
Figure 4-15
Follow
Step 11
VDS-IS Software" section on page
CDE280 Model Migration
CDE280 has 6 sub-prototypes and VDS-IS supports CDE280 prototype migration between those 6
sub-prototypes. This section will explain how to change a CDE280 sub-prototype to another CDE280
sub-prototype.
Configuration on CDE280 box will be reserved with only model change to new one after this process.
Note
In addition to that, the external disk will be formatted and no caches contents will be preserved.
The main difference between the 6 sub-prototypes is the drives.
Table 4-5
Table 4-5
CDE280 Variation
2H1
2H13
2H26
2S5
2S10
2S21
For example, to migrate from CDE280-2S5 to CDE280-2S10, do the following:
Switch off the device by clicking the Power button on the front panel of the device.
Step 1
Pull out all the external drives (24 x 240G SSD) of the device.
Step 2
Push the 24 x 480G SSD drives into the device as the CDE280-2S10 should have the 24 x 480G SSD the
Step 3
external drive only.
Power on the device.
Step 4
Rebooting the Server
Step 10 to Step 14 from the
lists the internal and external drives of each CDE280 sub-prototype.
Internal and External Drives of the CDE280 Sub-prototype
Internal Drives
480G SSD x 2
480G SSD x 2
480G SSD x 2
480G SSD x 2
480G SSD x 2
480G SSD x 2
Cisco Content Delivery Engine 205/220/250/280/285/420/460/475 Hardware Installation Guide
"Connect to the Console" section on page 4-7
4-7.
Re manufacturing a CDE
and "Configure
External Drives
600G HDD x 1
600G HDD x 24
1200G HDD x 24
240G SSD x 24
480G SSD x 24
960G SSD x 24
4-23