Cisco CDE 220 Series Hardware Installation Manual page 180

Re-Manufacturing a CDE
Figure 6-5
Install the VQE Software for CDE280:
Step 4
a.
Power on the CDE.
Step 5
Once the CD starts booting, it displays a spinning "|" symbol for approximately five minutes. Allow the
booting to proceed and monitor the sequence from a remote terminal provided by the terminal server.
The Installer main menu is displayed at the conclusion of the boot sequence; you should see a menu
similar to this:
Un-mount the ISO file:
Step 6
From the Virtual Media tab, select Activate Virtual Devices.
Note
From the Power tab, select Power Cycle Systems (cold boot) to reboot the server.
Step 7
To connect to the Console, see
Step 8
Software, page
Installing the VQE Software
To install the VQE software, see
Cisco CDA Visual Quality Experience Application Release 3.11.
Cisco Content Delivery Engine 205/220/250/280/285/420/460/475 Hardware Installation Guide
6-6
Rebooting the Server
Connect to the serial console of CDE280:
Enter the IP address of the server with admin as the username and the password previously set.
–
user1$ ssh -l admin 10.140.104.17
admin@10.140.104.17's password: XXXXX
C240-FCH1852V20Y#
Enter the following command:
–
C240-FCH1852V20Y# connect host
When you select Activate Virtual Devices, the system prompts whether you want to unmount
the iso file or not.
6-2.
Chapter 6 Installing the VQE and Initially Configuring a CDE
"Connect to the Console" section on page 4-7
Installing VQE Release 3.11 Software"
and Configure VQE
section in the Release Notes for