Cisco CDE 220 Series Hardware Installation Manual page 135

Chapter 4 Installing the VDS Internet Streamer Software and Initially Configuring a CDE
Launching a CDE280 for the First Time
For CDE280, you can use the CIMC to manage your device. To use the CIMC, you have to configure it.
This section describes the following tasks:
•
•
•
•
•
Configure the CIMC IP
This section describes how to configure the CIMC. It is strongly recommended that you leave this
Note
connection as a permanent connection. There should be a permanent IP address and a cable permanently
connected to switch/router associated with this connection. The CIMC will benefit monitoring, general
troubleshooting and troubleshooting system alarms of this system.
Attach an Ethernet cable to the Management port of the CDE280 and also attach a monitor to the CDE
Step 1
280. The Management port is labeled M. See
Figure 4-1
Power on the server and press F8 when the CIMC configuration screen appears.
Step 2
Configure the device with the options shown below:
Step 3
a.
b.
c.
Configure the CIMC IP, page 4-3
Configure Remote Presence, page 4-5
Connect to the Console, page 4-7
Configure VDS-IS Software, page 4-7
Configuring SNMP, page 4-8
Attaching the Ethernet Cable
Enter your IP, subnet mask and gateway addresses.
Press the Space Bar to apply the new IP configuration.
Press F10 to save the configuration and press <esc> to exit
Cisco Content Delivery Engine 205/220/250/280/285/420/460/475 Hardware Installation Guide
Launching a New CDE for the First Time
Figure 1-10 on page 1-11 to find the port.
4-3