Cisco CDE 220 Series Hardware Installation Manual page 159

Chapter 4 Installing the VDS Internet Streamer Software and Initially Configuring a CDE
After the reload, run the command "disk policy apply" to set up the drives.
Step 6
The device changes to CDE280-2S5. To check the device that you are currently working on, run the
following command:
The system displays the following:
Installing the VDS-IS Software
For a CDE280 Engine, you do not have to refer this section.
Note
Perform the following steps to install the software:
Launch the Installer. You will see something like this:
Step 1
Welcome to the installer.
of a new software image onto your system, or recover a previous image
in the event that the hardware was changed.
MODEL: CDE205
FLASH: found, directory validated
COOKIE: valid
IMAGE: DEVELOPMENT[vcn-build2:/auto/vcn-u1/carlowan/refact-dev-1/spcdn
FLASHDEV: /dev/hda
Installer Main Menu:
Choice [0]:
Manufacture the IDE compact flash drive by selecting Option 2. This makes the IDE compact flash drive
Step 2
bootable. Enter Y to confirm the process.
Note
At the Installer Main Menu, choose Option 9 to force the manufacturing flash. You should see
Step 3
something like this:
#disk policy apply
#
#show inventory
PID: CDE280-2S5 VID: 01 SN: FCH1834V3AU
1. Configure Network
2. Manufacture flash
3. Install flash cookie
4. Install flash image from network
5. Install flash image from cdrom
6. Install flash image from disk
7. Wipe out disks and install .bin image
8. Exit (and reboot)
9. Force manufacturing flash
This step is not necessary if the IDE compact flash drive has been previously manufactured. The
system produces an error; ignore the error and proceed.
Cisco Content Delivery Engine 205/220/250/280/285/420/460/475 Hardware Installation Guide
The installer will enable installation
Re manufacturing a CDE
4-27