Table of Contents
Advertisement
UV SAFETY PRECAUTIONS
DO NOT LOOK DIRECTLY INTO THE (UV) LIGHT AND/OR VIEW (UV) LIGHT DIRECTLY WITH OPTICAL
INSTRUMENTS THAT MAY CONCENTRATE THE LIGHT/RADIATION OUTPUT.
INDIVIDUALS SUFFERING FROM A RANGE OF EYE CONDITIONS, SUNLIGHT EXPOSURE DISORDERS, OR
INDIVIDUALS USING PHOTOSENSITIVE MEDICATION, MAY RECEIVE DISCOMFORT IF EXPOSED
OPERATION
General Operation: The ADJ Eco UV Bar Plus IR contains an electronic ballast, which will auto sense the
voltage when it is plugged into the power source. With the electronic voltage switch you do not need to worry
about wall voltage, this unit can be plugged in anywhere. This fixture is designed to operate as a stand alone
unit. It has been tested and there is no assembly necessary. The Eco UV Bar Plus IR is ready to be plugged in
out of the box. Plug the unit in to a matching power outlet or into a power pack and "flip" the power switch to
the On position. Use the included UC IR to control the unit. See page 6 for controls.
POWER CORD DAISY CHAIN
With this feature you can connect the fixtures to one another using the IEC input and output sockets.
The quantity that can be connected is 10 fixtures maximum. After 10 fixtures you will need to use a
new power outlet. They must be the same fixtures. DO NOT mix fixtures.
UC IR/AIRSTREAM APP CONTROL
The UC IR infrared remote (Included) gives you control of various functions (See below). To control the fixture
you must aim the remote at the front of the fixture and be no more than 30 feet away.
The Airstream IR (sold separately) remote transmitter plugs into the headphone jack of your iOS phone or
tablet. To control your IR fixture you must raise the volume to the maximum on your iOS phone or tablet and
aim the transmitter at the fixture sensor and be no more than 15 feet away. After you have purchased the
Airstream IR transmitters, the app is a free download from the app store for your iOS phone or tablet. The app
comes with 3 pages of control depending on the fixture you are using. Please see below for IR functions. This
unit works with App page 1.
STAND BY - Pressing this button will blackout the fixture.
FULL ON - Press this button down to fully light up the unit.
FADE/GOBO - Press this button to activate UV fade mode. Press button 1 for slow fade, button 2 for medium
fade, and button 3 for fast fade.
"DIMMER +" and "DIMMER -" - Use these buttons to adjust the output intensity when UV color mode is
active.
STROBE - Press this button to activate strobing. Press button 1 for slow strobe, button 2 for medium strobe,
button 3 for fast strobe, and button 4 for the fastest strobing.
COLOR - Press this button to activate UV color mode. Adjust the output intensity using the "DIMMER +" and
"DIMMER -" buttons.
1-9 - When in strobe use buttons 1-4 to adjust the strobe rate. In fade mode use buttons 1-3 to adjust the fade
speed.
SOUND ON & OFF - These buttons are invalid for this fixture.
SHOW - This button is invalid for this fixture.
A.D.J. Supply Europe B.V. – www.americandj.eu – Eco UV Bar Plus IR User Manual Page 6
Advertisement
Table of Contents
