Power Cord Daisy Chain - ADJ REVO 4 IR User Manual

Revo 4 IR
Primary-Secondary Configuration. This function will allow you to link up to 16 units together and
operate without a controller. In a Primary-Secondary set up, one unit will act as the controlling unit
and the others will react to the controlling units programs. Any unit can act as a Primary or as a Sec-
ondary.
1. Using approved DMX data cables, daisy chain your units togeth-er via the XLR connector on the
rear of the units. Remember the Male XLR connector is the input and the Female XLR connector
is the output. The first unit in the chain (primary) will use the female XLR connector only - The last
unit in the chain will use the male XLR connector only. For longer cable runs we suggest a
terminator at the last fixture.
2. On the Primary unit press the MENU button until "SCND" is displayed, and press ENTER. Use the
UP and DOWN buttons to scroll to the "PRI" setting and press ENTER.
3. After setting the Primary unit to the primary setting find and set your desired operating mode.
4. On the secondary units press the MENU button until "SCND" is displayed, and press ENTER.
Choose either "SEC 1" or "SEC 2" and press ENTER. See page 9 for more info.
5. The secondary units will now follow the Primary unit.
Revo 4 IR
With this feature you can connect the fixtures to one another using the IEC input and output
sockets. The quantity that can be connected is 12 fixtures maximum for 120V and 21 fixtures
maximum for 230V. After the maximum amout of fixtures is connected you will need to use a
new power outlet. They must be the same fixtures. DO NOT mix fixtures.
ADJ Products, LLC - www.adj.com - Revo 4 IR User Manual Page 12
Primary-Secondary Configuration

Power Cord Daisy Chain