Primary-Secondary Set Up; Power Cord Daisy Chain - ADJ Startec STINGER User Manual

Stinger
Primary-Secondary Set Up: This function will allow you to link up to 16 units together and operate
without a controller. In a Primary-Secondary set-up one unit will act as the controlling unit and the
others will react to the controlling units programs. Any unit can act as a Primary or as a Secondary.
1. Using stand XLR microphone cables, daisy chain your units together via the XLR connector on
the rear of the units. Remember the Male XLR connector is the input and the Female XLR con-
nector is the output. The first unit in the chain (Primary) will use the female XLR connector only,
and the last unit in the chain will use the male XLR connector only. For longer cable runs, it is
advisable to use a terminator on the last fixture.
2. Set the Primary to your desired operating mode.
3. Set the Secondary unit(s) to address "001".
4. The Secondary unit(s) will now follow the Primary.
Stinger
With this feature you can connect the fixtures to one another using the IEC input and output sockets.
The maximum number of fixtures that can be connected is 10 fixtures. After exceeding this
value, a new power outlet must be used in order to accommodate additional fixtures.
All daisy chained fixtures should be of the same model type. DO NOT mix fixtures.
ADJ Products, LLC - www.adj.com - Stinger User Manual Page 13

Primary-Secondary Set Up

Power Cord Daisy Chain