Remote Ip Address; Remote Port - Lantronix CoBox-Micro User Manual

Configuration
To enter command mode:
There must be 1-second guardtime (no datatraffic) before sending +++.
There must not be a break longer that 1 second between +s.
There must be another 1 second guardtime after the last + is sent.
The Device Server acknowledges with an OK to indicate that it is in command
mode.
Enter ATH and press Enter. It is echoed if echo is enabled. ATH is acknowledged
by another OK.
Command
ATDTx.x.x.x,pppp or
ATDTx.x.x.x/pppp
ATDTx.x.x.x
ATD0.0.0.0
ATD
ATDx.x.x.x
ATH
Note: All other AT commands with Modem Mode set to 16 or D6
acknowledge with an OK, but no action is taken.

Remote IP Address

Selecting Autostart (automatic connection) in Connect Mode makes a connection to this IP
address on the network. This is the destination IP address used with an outgoing
connection.

Remote Port

The remote TCP port number must be set to use automatic connections. This parameter
defines the port number on the target host to which a connection is attempted.
Table 7-6: Modem Mode Commands
Function
Makes a connection to an IP address (x.x.x.x) and a remote port num-
ber (pppp).
Makes a connection to an IP address (x.x.x.x) and the remote port
number defined within the
Device Server
Forces the
and port number are defined within the
Device Server
Forces the
and port number are not defined within the
Makes a connection to an IP address (x.x.x.x) and the remote port
number defined within the
Hangs up the connection (Entered as +++ ATH).
Serial Channel (Port) Configuration
Device Server
.
into monitor mode if a remote IP address
Device Server
into monitor mode if a remote IP address
Device Server
Device Server
.
.
.
7-11