Network Configuration Using Udp; Network Configuration Using A Hex File - Lantronix CoBox-Micro User Manual

Configuration

Network Configuration Using UDP

To enter Setup (configuration) Mode, cycle the Device Server's power (power off and back
on). After power-up, the self-test begins and the Diagnostic and Status LEDs start blinking.
You must enter three lowercase "x" characters (xxx) within one second after powering up
in order to start the configuration mode.
Note: The easiest way to enter Setup Mode is to hold down the "x" key on
your keyboard while powering up the Device Server.
Network Configuration Using UDP
The Device Server can also be configured or queried over the network using UDP
datagrams. For more information, see Network Configuration Using UDP on page E-1.

Network Configuration Using a Hex File

When configuring a number of Device Servers identically, it is useful to create a template
setup record. For more information, see Network Configuration Using a Hex File on page
E-3.
7-3