Time Setting - Tesla RoboStar T50 Manual

7. The "EDGE/WALL" (7) button

Push to command the vacuum cleaner to start cleaning along the walls and edges
(put the vacuum cleaner near the wall, aprox. 10 cm).
8. The "MAX" (8) button

After push, the suction force is increased, for deep cleaning. It is used for larger floors or
if the cleaning is to be carried out in shorter time. By activating it, pressing the "8" button
on the remote control increases the suction power of the vacuum cleaner to maximum
power.
SINGLE ROOM MODE
RETURN TO THE CHARGING STATION
After pressing the button, the vacuum cleaner searches for the charging station and starts charging.

TIME SETTING

 Push the „9" (CLOCK) button on the remote control to enter the "Time Setting" mode
 The time will flash on the bottom line of the display.

Use the directional buttons to adjust the time (HH: MM).
 Push the „9" (CLOCK) button again to confirm and save the set time.
 Successful time setting will be confirmed by a beep sound on the vacuum cleaner.
SCHEDULE CLEANING

The vacuum cleaner can be programmed to clean automatically once a day at a specified time,
even when there is no one at home. The current cleaning time and time is set using the remote
control.
 Make sure the "AUTO" mode button on the vacuum cleaner flashes green. If not, press the
"AUTO" mode button on the vacuum cleaner or the "7" button on the remote control.
 When programming the vacuum cleaner with the remote control, point the remote toward the
robot. Each step in setting the cleaning time of the vacuum cleaner with the remote will be
confirmed by a beep. If the beep does not hear, the step has not been saved.
This mode is used if the vacuum cleaner has
to clean only one room. Close the door to the
room and press the "AUTO" mode button on
the vacuum cleaner twice or the "7" button on
the remote control twice.
After cleaning, the vacuum cleaner stops and
beep.