Solving Problems - Tesla RoboStar T50 Manual

Keep clean the front bumper underneath the sensor for detecting objects.
Charging contacts and charging base
Clean the contacts on the bottom of the vacuum cleaner and the charging base with a soft cloth.
DESCRIPTION OF STATUS
Status
The vacuum cleaner is charging
The vacuum cleaner is 100% charged
The vacuum cleaner is ON and is in Standby mode
The vacuum cleaner needs to be checked, a problem
has arisen
Low battery charge
DESCRIPTION OF SOUND SIGNALS
Short tone
1x beep
2x beep
3x beep
4x beep

SOLVING PROBLEMS

Problem
The vacuum cleaner
1 battery can not be
charged.
Cause
The front wheel or the side
brushes do not work.
Cliff sensor or front
bumper sensor failure.
The vacuum cleaner got
jammed.
Error of main center
brush.
Cause
The vacuum cleaner is not
properly parked in the
charging base.
The charging base is not
connected to the mains and
the vacuum cleaner is
turned on by the main
switch.
Button „AUTO"
Blinking orange light
Solid green light
Flashing green light
Solid red light
Solid orange light
Solution
Check the front wheel and the side
brushes and clean them.
Clean cliff sensor and shake bumper
slightly, check whether there is any
obstacle.
Check the front wheel and the side
brushes and clean them.
Clean the main center brush, see
chapter "Maintenance".
Solution
Ensure that the charging
contacts are properly connected
when parked in the charging
base.
The charging base should
always be connected to the
mains, do not switch it off. The
vacuum cleaner is then always
ready for further cleaning with a
fully charged battery.