Preset Storage And Recall - Source Audio Collider Delay+Reverb User Manual

Preset Select/(Hold) Save Button and LEDs
Press the SELECT button to scroll through and select saved user presets. The four P
the P B indicate which preset is active for presets 1 through 4. If a preset has been
RESET UTTON
modified, the corresponding P
– the associated preset LED will blink for a few seconds. When the LED stops blinking, the updated
preset will be saved to the current preset position.
Preset Extension Mode: Allows for easy access to an additional 4 presets for a total of 8 onboard
presets. To enable Preset Extension Mode, go to the Hardware Options sections of the Neuro Mobile
or Desktop Editor (see
patterns of the Preset Select LEDs indicate which Preset has been selected (see the figure below).
Preset Extension Mode can also be enabled as a hardware shortcut on the Collider itself. To Enable
Preset Extension Mode, hold down the CONTROL INPUT button + press the PRESET SELECT button.
Note: when using a MIDI controller to select a preset outside of the normal bank (presets 1 to 4) or
extended bank (presets 5 to 8), then all 4 P
between 9 and 128 is active. For details on preset editing and saving, see the next section.

Preset Storage and Recall

User Presets store all user editable parameters. This includes the knob positions, current effect
engines, routing options, external control, and the full list of Neuro/MIDI accessible parameters.
Included in every preset are settings for either position of the KNOBS Switch (Delay or Reverb). After
a preset is recalled, you can always tweak it in a performance situation by turning a knob. The knob
parameter will then "jump" to the knob position as the knob is moved.
Recalling Presets
The first 4 User Presets (or 8 in Preset Extension Mode) are accessible via the onboard hardware or
with and external footswitch in the following ways:
1. Click the SELECT button to cycle through the hardware user presets. This function works
whether the pedal is engaged and bypassed.
2. When the pedal is engaged, press and hold the ON/OFF Footswitch to scroll upward through
user presets
3. When the pedal is bypassed, tap the OPTION Footswitch to scroll upward through the user
presets, or press and hold the OPTION Footswitch to scroll downward through user presets.
4. Connect an external footswitch to the PEDAL IN jack and select SWITCH mode (located next to
the PEDAL IN jack) to scroll upward through presets. Please note that it is possible to reassign
the function of external single and dual footswitches in the
Neuro Desktop or Mobile App Editors – these control assignments are global.
SA263
LED will blink slowly. To save a preset, press and hold this button
RESET
Neuro Hardware Options) and select the appropriate option. The illumination
RESET
Collider Delay+Reverb Owner's Manual
LED will be lit, indicating that a preset in the range
S
Hardware Options
LED next to
RESET S
section of the
18