Source Audio Collider Delay+Reverb User Manual page 29

Configuring the Hot Hand
When the Hot Hand is connected to the Collider, follow these simple steps to calibrate it and map it
to control different effect parameters.
1. Press the C
ONTROL
2. Press and hold the C
(approximately one blink per second).
3. Move the Hot Hand ring over the range of motion you would like to use to control the
Collider. The easiest way to do this is to move the ring in the same way that you intend to
move it as you perform. The Collider will intelligently select the X or Y axis of the Hot Hand
automatically, based on the motion of the ring.
4. After setting Hot Hand range of motion, click the O
now complete, and the C
time to map the Hot Hand to the effect parameters.
5. Move the knobs and Neuro parameters (Neuro parameters are only accessible when
connected to the Neuro Mobile App or Neuro Desktop Editor) you wish to control with the
Hot Hand to their minimum desired position and then click the O
C L
ONTROL ED
control one or more knobs with the Hot Hand, up to four total knobs.
6. Move the knobs and Neuro parameters you wish to control with the Hot Hand to the
maximum desired position and then click the O
be lit solid red.
7. After setting the minimum and maximum knob positions, the parameter mapping is
complete.
Reset Expression Control Mapping
To clear the expression control mapping (Expression or Hot Hand), first press the C
B to turn OFF control mode. The C
UTTON
I B until the C
NPUT UTTON
resets external control back to the default Input Volume Control.
External Control Options Guide
For a quick reference guide to all of the Collider's external control options, download the Collider
Delay+Reverb Control Options Guide found at the bottom of the
Source Audio website.
SA263
I B to enable external control. The C
NPUT UTTON
I B
ONTROL NPUT UTTON
L
ONTROL ED
will now blink even faster (about 4 blinks per second). Note that you may
ONTROL
L blinks 3 times. This clears all expression or Hot Hand mapping and
ONTROL ED
Collider Delay+Reverb Owner's Manual
until the C L
ONTROL
/O F
N FF OOTSWITCH
will blink faster (about 2 blinks per second). Now, it is
/O F
N FF OOTSWITCH
L should be off. Then, press and hold the C
ED
Collider Delay+Reverb page
L should be lit red.
ONTROL ED
begins to blink slowly
ED
once. The calibration is
/O F . The
N FF OOTSWITCH
. The C L will now
ONTROL ED
I
ONTROL NPUT
ONTROL
on the
29