Source Audio Collider Delay+Reverb User Manual page 27

Hide thumbs Also See for Collider Delay+Reverb:
Table of Contents

Advertisement

External Switch Used As Expression Input (Expression "Toggle")
An external switch can also work as a sort of expression pedal that only has two positions: on and off.
The external switch can be either momentary or latching.
External Switch as Expression Toggle (1/4" TRS Connection – PEDAL IN Jack)
To use this mode, connect an external switch to PEDAL IN and set the PEDAL IN switch to the EXP
position instead of the SWITCH position. The following plug configuration is required:
Follow these steps for configuration:
1. Press the C
ONTROL
red.
2. Press and hold the C
(approximately one blink per second).
3. Tap the external switch once.
4. Click the O
N
second). Now, it is time to map the external switch to the effect parameters.
5. Move the knobs and Neuro parameters (Neuro parameters are only accessible when
connected to the Neuro Mobile App or Neuro Desktop Editor) you wish to control with the
expression pedal to the minimum desired position and then click the O
The C
ONTROL
control one or more knobs with the expression pedal, up to six total knobs.
6. Move the knobs and Neuro parameters you wish to control with the expression pedal to the
maximum desired position and then click the O
be lit solid red.
7. After setting the minimum and maximum knob positions, the parameter mapping is
complete.
External Switch as Expression Toggle (1/8" (3.5mm) TRRS Connection – CONTROL INPUT
Jack)
To use this mode, connect an external switch to C
S
position instead of the E
WITCH
SA263
I
B
to enable external control. The C
NPUT
UTTON
I
B
ONTROL
NPUT
UTTON
/O
F
once. The C
FF
OOTSWITCH
L
will now blink even faster (about 4 blinks per second). Note that you may
ED
position. The following plug configuration is required:
XP
Collider Delay+Reverb Owner's Manual
until the C
L
begins to blink slowly
ONTROL
ED
L
will blink faster (about 2 blinks per
ONTROL
ED
/O
F
N
FF
OOTSWITCH
I
and set the P
ONTROL
NPUT
L
should be lit
ONTROL
ED
/O
F
N
FF
OOTSWITCH
. The C
L
will now
ONTROL
ED
I
S
to the
EDAL
N
WITCH
.
27

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Collider Delay+Reverb and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Sa263

Table of Contents