Source Audio Collider Delay+Reverb User Manual page 19

Recalling MIDI Presets
All 128 available User Presets are accessible with an external MIDI controller. MIDI controllers can be
connected via either the 5-Pin DIN (MIDI IN) jack on the side of the pedal, the USB port at the top of
the pedal, or through a Neuro Hub, which connected to the CONTROL INPUT at the top of the pedal.
All 128 User Presets can be recalled with the corresponding MIDI program change (PC) messages.
Note: When recalling presets via MIDI PC messages, you may wish to queue up your preset with
effect bypassed. To do this, simply engage the preset, bypass it with the ON/OFF footswitch, then re-
save the preset normally. When recalled, the pedal will load the saved user settings, but the effect
will be bypassed. To engage the preset, simply press the ON/OFF Footswitch on the Collider.
Copying a Preset to a New Location Using the Select/(Hold) Save Button
1. Select the preset you would like to copy by pressing the SELECT/(HOLD) SAVE Button until the
corresponding P
2. Press and hold the SELECT/(HOLD) SAVE Button for one second until the corresponding P
LED begins blinking rapidly. Quickly release the SELECT/(HOLD) SAVE Button. The P
should continue to blink rapidly. This indicates that the Collider is in copy mode.
3. Tap the SELECT/(HOLD) SAVE Button to increment the preset. The corresponding P
should continue to blink rapidly. Tap the SELECT/(HOLD) SAVE Button again until the desired
copy destination is selected.
4. Press and hold the SELECT/(HOLD) SAVE Button until the P
solid. This indicates that the preset has been saved to the new location. The original location
will not be changed or overwritten.
Copying a Preset to a New Location Using an External MIDI Controller
1. Select the preset you would like to copy by sending a MIDI program change message to the
Collider.
2. Press and hold the SELECT/(HOLD) SAVE Button for one second until the corresponding P
LED begins blinking rapidly. Quickly release the SELECT/(HOLD) SAVE Button. The P
should continue to blink rapidly. This indicates that the Collider is in copy mode.
3. Send a desired MIDI Program Change number to indicate the desired copy destination for the
preset.
4. P LED will blink fast and then turn solid. This indicates that the preset has been saved to
RESET
the new location.
Copying a Preset to a New Location Using the Neuro App
Using the BURN command in Neuro Mobile or Desktop Editors, it is possible to copy presets to any
location in memory.
Clearing all Presets
The entire range of 128 User Presets can be erased using the Factory Reset procedure. Warning: the
Factory Reset procedure resets the entire pedal back to the state in which it was originally shipped –
this includes all global settings, swapped reverb engines in the Effect Selector knob, and User Presets.
A Factory Reset will not change any firmware updates.
SA263
LED is lit.
RESET
Collider Delay+Reverb Owner's Manual
LED blinks slowly and then turns
RESET
RESET
LED
RESET
LED
RESET
RESET
LED( )
RESET S
19