Preset Storage And Recall - Source Audio Nemesis Delay User Manual

LED will remain lit solidly. Release the TAP switch to disable HOLD mode and resume normal effect
operation.
Control Input Button
This small button is used when configuring external control. See the
more details.
External Control LED
The small LED located to the left of the M
that external control mode (expression or MIDI) is active or when incoming data is being received via
MIDI or a Neuro connection. For more information, see the
Preset Select Button and LEDs
Press the SELECT button to recall a saved user preset. The four P
indicate which preset is active for presets 1 through 4. If a preset has been modified, the
corresponding P
RESET
Preset Extension Mode
firmware version 1.12 and later), presets are indicated as shown in this figure:
If a user has used a MIDI controller to select a preset outside of the normal bank (presets 1 to 4) or
extended bank (presets 5 to 8), then all 4 P
between 9 and 128 is active. For details on preset editing and saving, see the next section.

Preset Storage and Recall

The Nemesis features 128 user presets. User Presets store all user editable parameters. This includes
the knob positions, current effect engine, the full list of Neuro/MIDI accessible parameters, and the
current settings for external control. After a preset is recalled, you can always tweak it in a
performance situation by turning a knob. The knob parameter will then "jump" to the knob position
once the knob is moved.
Recalling Presets
By default, 4 of the 128 presets are accessible via the hardware. Presets can be recalled via hardware
in three ways:
- Press the SELECT button to cycle through the hardware user presets.
- When the effect is bypassed, you can press and hold the TAP footswitch to perform the same
function as the SELECT button to cycle through the presets.
- Connect an external footswitch to the PEDAL IN jack and use SWITCH mode to step through
presets.
SA260
K
IX NOB
LED will blink slowly.
allows for easy access to 8 presets instead of just 4. In this mode (as of
1 2
5 6
RESET
Nemesis Delay User's Guide
External Control
is the C /ACTIVITY L
ONTROL
External Control
LED
RESET
3
7
LED will be lit, indicating that a preset in the range
S
section for
. When lit, it indicates
ED
section.
next to the P B
S RESET UTTON
4
8
23