Source Audio Collider Delay+Reverb User Manual page 7

MIDI Input
This is a standard 5-pin DIN connector that accepts MIDI control messages from external devices,
including program change (PC) and continuous controller (CC) messages. Please email
contact@sourceaudio.net
implementation.
Output Side Connections
Output 1
This is the primary audio output. Connect it to your amplifier, recording interface, or the next device
in your effects signal chain using a mono (TS) ¼" cable.
Output 2
O 2 can act either as an audio output, external loop output, or as the daisy-chain data
UTPUT
connection for the Neuro App.
•
Output 2 as an Audio
carries an audio signal when the Collider is configured with a signal routing that uses stereo
outputs. Connect it to your amplifier, recording interface, or the next device in your effects
signal chain using a mono (TS) ¼" cable.
•
Output 2 as an External Loop Send:
an external loop, O
the input of the external effects loop using a mono (TS) ¼" cable.
•
Output 2 as a Neuro App Data Daisy-Chain Output:
connection for the Neuro App, passing data from the Collider to the next Source Audio effect in
your signal chain. You can daisy-chain the Neuro App data regardless of whether O
configured to output audio or not. Connect O
(usually I 2) using a stereo (TRS) 1/4" cable. The audio signal (if applicable) will be on the tip
NPUT
contact of the plug, and the Neuro App data will be on the ring contact. This allows audio and
Neuro data to flow on the same cable.
SA263
regarding any questions about the Collider Reverb+Delay's MIDI
Output: The tip contact on O
If the Collider is configured in a routing mode that includes
2 is the loop send and I
UTPUT
Collider Delay+Reverb Owner's Manual
2 acts as the secondary audio output. It
UTPUT
2 is the loop return. Connect O
NPUT
The ring contact on O
2 to the next device's Neuro App Data input
UTPUT
2 to
UTPUT
2 acts as a data
UTPUT
2 is
UTPUT
7