Source Audio Collider Delay+Reverb User Manual page 28

Gr ound
Follow these steps for configuration:
1. Press the C
ONTROL
red.
2. Press and hold the C
(approximately one blink per second).
3. Tap the external switch once.
4. Click the O /O
N
second). Now, it is time to map the external switch to the effect parameters.
5. Move the knobs and Neuro parameters (Neuro parameters are only accessible when
connected to the Neuro Mobile App or Neuro Desktop Editor) you wish to control with the
expression pedal to the minimum desired position and then click the O
The C
ONTROL
control one or more knobs with the expression pedal, up to six total knobs.
6. Move the knobs and Neuro parameters you wish to control with the expression pedal to the
maximum desired position and then click the O
be lit solid red.
7. After setting the minimum and maximum knob positions, the parameter mapping is
complete.
Hot Hand Input
The Hot Hand 3 Wireless Effects Controller can be connected directly to the C
wireless motion control of the Collider Delay+Reverb's effect parameters. The Hot Hand has two axes
of expression: X and Y. These signals are carried on the two rings of the TRRS cable that comes from
the Hot Hand receiver. The Collider uses the X expression signal.
SA263
Switch Out
I B to enable external control. The C
NPUT UTTON
I B
ONTROL NPUT UTTON
F once. The C
FF OOTSWITCH
L will now blink even faster (about 4 blinks per second). Note that you may
ED
Gr ound
Y Exp
Collider Delay+Reverb Owner's Manual
1/ 8" (3.5mm)
Power (Switch pul l -up)
until the C L begins to blink slowly
ONTROL ED
L will blink faster (about 2 blinks per
ONTROL ED
/O F
N FF OOTSWITCH
Power
X Exp
L should be lit
ONTROL ED
/O F
N FF OOTSWITCH
. The C L will now
ONTROL ED
I jack for
ONTROL NPUT
.
28